GOBLIN FIREBALL (with standard motor, ESC, 4 servos and blades )

SAB Heli Division
SABSG281
Bestel
  • Beschrijving

Download Manual

EASIER THAN EVER

Simplicity is the key feature of the Goblin Fireball

The goal of the project was to design a simple model with, good performance that crashes well and is fast, simple and cheap to repair.

For fun, for training, for HARD 3D it must be the Goblin Fireball!

Registered design 003738210-0001/0004

 

SPECIFICATIONS
General Specifications:
  • Main rotor diameter: 626 mm
  • Main blade length: 280mm
  • Tail rotor diameter: 139 mm
  • Tail blade length: 50 mm
  • Main shaft diameter: 5 mm
  • Tail shaft diameter: 3 mm
  • Weight including electronics: 735g (excluding batteries)
  • Direct standard Motor included
  • Cyclic servos included ( 3x DS12C )
  • Tail servo included ( 1x DS12T )
  • ESC 60A included
  • 4 servo horn included
  • Typical battery setup: 6S 1000/1250 mAh

 

http://www.goblin-helicopter.com/shop/images/SG280/F-resize.jpg

      

    MAIN FEATURE

    With the new-patented "Direct Drive" system, this has been achieved.

    The reduced parts count delivers maintenance that has never been easier! Carefully selected materials used in the soft plastic

    landing gear, plastic blade grips arms, hard steel shaft, strong plastic frames and a polycarbonate canopy and boom secure

    minimal crash damage and reduce repair bills.

    http://www.goblin-helicopter.com/shop/images/SG281/E.jpg


      FEATURES
      http://www.goblin-	http://www.goblin-helicopter.com/shop/images/SG280/G-resize.jpg.com/shop/images/Thunder (01).jpghttp://www.goblin-helicopter.com/shop/images/SG280/H-resize.JPGhttp://www.goblin-helicopter.com/shop/images/SG280/I-resize.JPGhttp://www.goblin-helicopter.com/shop/images/SG280/L-resize.JPG
      • Cheap to replace the polycarbonate canopy and boom
      • Easy maintenance, the rotor head can be removed with only 2 screws
      • Motor shaft and main shaft are connected with a mechanical joint
      • Plastics blade grip arms become a sacrificial part to protect other vital components. For simplicity the arms can be replaced with 1 screw
      http://www.goblin-helicopter.com/shop/images/SG280/M-resize.JPGhttp://www.goblin-helicopter.com/shop/images/SG280/N-resize.JPGhttp://www.goblin-helicopter.com/shop/images/SG281/O.jpghttp://www.goblin-helicopter.com/shop/images/SG280/Q-resize.JPG
      • Super strong rotor head design delivers resilience in a crash
      • Magnetic canopy release system
      • Micro tail servo 23mm size
      • Serial number on the main plate and on your registration card. 
        When you register your kit you are helping us to fully support YOU the “Goblin way”.